camry Premium CR 5018 Instrucciones De Uso página 4

when you rotate the iron, as in the tank, even when disconnected from the power
supply iron, may still be in hot water.
19. DO NOT allow for prolonged contact hot steam iron with fabric or flammable materials.
20. Be careful that the power cord does not touch the hot soleplate. Allow the iron to cool
completely before storage.
21. If you do not use iron, even for a short time, turn off the options of steam
22. Under no circumstances should be ironed clothes and fabrics that are on humans or
animals.
23. Never direct the steam to humans or pets.
24. Use self-cleaning function at least once a month.
25. Iron must be used at a stable even surface and this can only be disposed of.
26. Do not fill the water tank with chemicals, perfumes or descaling substance.
DESCRIPTION OF DEVICE
A. Spray nozzle
C. Steam Control Lever
E. "Steam blast" button
G. Rotary cable gland
I. Thermostat knob - temperature control
K. Water tank
ANTI-CALC function
A special resin filter inside the water reservoir softens the water and prevents scale build-up in the plate. The resin filter is permanent
and does not need replacing.
PLEASE NOTE: Use tap water only. Distilled and/demineralised water makes the "Zero-Calc" anti-calc system ineffective by altering its
physicochemical characteristics.
ANTI-DRIP SYSTEM
The plate may cool down to the point where no more steam comes out, but rather drops of boiling water that can leave marks or stains.
Self-Clean Function
It is recommended that you periodically use the soleplate Self-Clean function which prevents scale build-up in your iron. In order to do
this, fill your iron entirely with water, sit it on its heel, connect to the mains and set the thermostat to "MAX". When the control light goes
out, disconnect the device from the mains and hold it in a horizontal position, e.g. over a sink. Press the Self-Clean button (J) and hold
the iron for about a minute, shaking it. When it cools down, clean the soleplate with a moist cloth to remove any dirt.
Intelligent automatic shutdown system
It has an automatic shutdown system that ensures maximum safety and energy savings at home. The automatic switch activates after 8
minutes in an upright position or after 30 seconds in a horizontal position, protecting the pressed clothes from possible scorching.
IRONING
First use: For the sake of customer safety, each iron is subjected to leak tests. This can cause the appearance of a drop of water
inside.
When using the iron for the first time, you may notice a slight emission of smoke and hear some sounds made by the expanding plastics. This
is quite normal and it stops after a short time. We also recommend passing the iron over an ordinary cloth when using it for the first time.
Preparation
Sort the laundry to be ironed according to the international symbols on the garment label, or if this is missing, according to the type of fabric.
Start ironing the garments requiring a low temperature.
This reduces the waiting times (the iron takes less time to heat up than to cool down) and eliminates the risk of scorching the fabric.
STEAM IRONING
Check that the plug is disconnected from the socket. Move the steam selector (C) to "0" . Open the lid (B). Raise the tip of the iron to
help the water enter the opening without overflowing. Slowly pour the water into the reservoir using the special measure and taking care
B. The water inlet hole
D. Spray button
F. Power Cord
H. Thermostat indicator light
J. Self-clean button
L. Steel soleplate
GARMENT
LABEL
Cotton - linen
FABRIC
TYPE
synthetic
low temperature
silk - wool
medium temperature
high temperature
ENGLISH
Fabric not to be ironed
4
THERMOSTAT
REGULATION
·
··
···