Publicidad
Idiomas disponibles
Idiomas disponibles
Operator's guide
1)Unpacking intruction
2)Cleaning
3)Installation
4)Connection to the mains
5)Controls and checking
6)Internal cleaning
7)Replacement of internal light bulbs
!
WARNINGS
(see picture 10)
ATTENTION: It is most important that this instruction booklet is kept together with the appliance
both for future reference and for reasons of safety.
1
. Adults should operate this appliance only. Do not allow children to use the controls or play with it. . It is
forbidden to modify in any way the main functions and characteristics of this appliance. .The electrical
installation of the appliance should be carried out by a qualified electrician or other competent person.
4. Never attempt to carry out repairs unassisted. Inexpert repairs can cause serious damage and
malfunction. . Assistance has to be provided by an authorized engineer only. Always use original spare
5
6
parts. . This appliance is not suitable for the storage of basic commodities not including food-stuffs. .The
manufacturers of this appliance accept no responsibility for the consequences of misuse in contravention
of these safety instructions. It further reserves the right to carry out improvements without prior notice.
8
. Avoid installing the cabinet directly in line with sunlight. . Never install the appliance near sources of
heat (such as radiators, stoves, etc) and drafts (such as windows, doors, ventilation systems, air
conditioning, etc ...).
10
evaporator, we recommend stopping the compressor and placing the goods in special refrigerated
containers, kept at the same temperature, until defrosting is completed;if this is not carried out the
compressor will continue to operate leading to a wasteful consumption of electricity and poor performance.
!
Our products are for internal use only do not install outside restaurants, shops.
1.
UNPACKING INSTRUCTIONS
1.
Cut the strap and remove the cardboard package by sliding it upwards.
the pallet or crate (see picture 1).
nothing left in the package before disposing of it.
disposal.
CLEANING
2.
1.
Clean the internal surfaces with a soft sponge and a neutral detergent
3.
INSTALLATION
(L) Drainage pipe (M) Electric cable (N) Liquid supply pipe Ø 6 (O) Suction pipe Ø 8 (P) Blue electric wire:
electronic control board supply (Q) Brown electric wire: electronic control board supply (R) Black electric
wire: UMC compressor connection or solenoid (S) Green-yellow electric wire: earthing (see picture 5)
1.
Place the appliance in the prepared space
drainage pipe to a normal drainage
(
See
picture 9)
CONNECTION TO THE MAINS
4.
1. Ensure that mains voltage and frequency are the same as those stated on the rating plate attached to
2
the appliance. . Ensure that the supply socket:
rated current as set out on the rating plate;
with In = rated value as stated on the rating plate; - differential with Id sensitivity = 30 mA. . Ensure that
there is no danger of explosion (AD) in the room. . The cable of the appliance is H05 VVF, designed for
internal use.
5
. Insert the plug in the socket (do not use three-way adapters and reduction adapters).
Operator's guide
. If damp air or products to be refrigerated should cause ice to form on the
4.
Place the appliance on a flat level surface.
6.
.
2
. Connect the refrigeration circuit pipes
. 4.
Connect the electric wires following the wiring diagram
a)
c)
complies with the IEC regulations:- thermal-magnetic switch
Maintenance manual (Page 45)
1) Cleaning the condenser
2) Wiring diagram, Diagram of refrigeration unit
9
2.
Sort out the packaging materials in order to facilitate
. 2.
b)
is properly earthed;
fulfils the requirements of the
4
5
2
3
7
Lift the appliance.
3.
Remove
5.
Make sure there is
Wipe with a soft dry cloth.
.
3
. Connect the
3
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO
Publicidad
