Publicidad
Idiomas disponibles
Idiomas disponibles
Care and cleaning of the vent hood.
Be sure electrical power is off and all surfaces are cool before cleaning or servicing any part
of the vent hood.
6
All manuals and user guides at all-guides.com
Stainless Steel Surfaces
Do not use a steel wool pad;
it will scratch the surface.
To clean the stainless steel surface, use
warm sudsy water or a stainless steel
cleaner or polish. Always wipe the surface
in the direction of the grain. Follow
the cleaner instructions for cleaning
the stainless steel surface.
Light Bulbs
CAUTION:
Allow bulbs to cool before touching
To change the light bulbs:
1. Remove the lamp lens cover by
inserting a small flat blade screwdriver
into each of the three slots and gently
prying it free.
NOTE: Do not remove the outer trim ring
(lamp assembly).
2. Wear gloves. Do not touch the bulb
with your bare fingers. Skin oils can
cause early lamp failure.
3. Grasp the bulb and pull it straight out.
4. Replace with the same wattage. Early
bulb failure and damage to or failure of
the transformer may occur if wattage
is too high.
These 12-volt, 20-watt halogen bulbs
with a G4 base are available at
specialty lighting stores and home
building centers.
To order replacement bulb no.
WB01X10239, contact the GE National
Parts Center at 1.800.626.2002 or
purchase from your local retailer.
5. Replace lamp lens cover by inserting
the three retaining tabs into the three
slots and pressing firmly in place.
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the
location of a dealer nearest you, please
call our toll-free number:
National Parts Center
800.626.2002
ge.com
.
Tab
NOTE: Make sure the tabs are inserted into the slots.
Use a small flat blade screwdriver
to remove the lamp lens cover.
Bulb
Outer trim ring
(lamp assembly)
Do not remove
Removable inner
lamp lens cover
Publicidad
