Descargar Imprimir esta página

Louisiana Grills 7 Serie Montaje Y Operación página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

Parts are located throughout the shipping carton, including underneath the grill. Inspect the unit, parts, and hardware blister
pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill
before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not
attempt to assemble. Shipping damage is not covered under warranty. Contact your dealer or Louisiana Grills® Customer
Service for parts.
www.louisiana-grills.com | USA: (480) 923-9632 | Canada (Toll Free): 1-877-942-2246
IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.
Tools required for assembly: screwdriver and level. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed, or unless otherwise mentioned.
1. MOUNTING THE SUPPORT LEGS TO MAIN CABINET
Parts Required:
Main Cabinet (#7)
1
x
Support Leg With Wheel (#16)
4
x
12 x
¼–20x½" Stainless Steel Screw (#B)
Installation:
Place a piece of cardboard on the floor to prevent scratching the unit
and parts during assembly. First, lift the main cabinet door off the
hinges, and place aside. Note illustration 1A.
Next, flip the main cabinet, bottom side pointed upward, on the
cardboard. Prepare the four support legs for installation, arranging
the labelled legs as shown in illustration 1B.
IMPORTANT: The four support legs must be arranged correctly to be
able to properly install the support panels and support bar in a later
assembly step.
Mount one support leg to the smoke cabinet using three screws. Repeat
installation for the other three support legs. Note illustration 1C.
2. SECURING THE CONTROL BOARD TO SUPPORT LEGS
Parts Required:
#10–24x½" Screw (#D)
2
x
Installation:
Near the Control Board, loosen the two pre-assembled screws
connecting the front panel to the main cabinet. Note 2A.
Next, using another two screws ( #D) , secure the front panel sides to
the front-facing support legs. Once these screws are tight, re-tighten
the two screws that were previously loosened in 2A. Note 2B.
ASSEMBLY PREPARATION
ASSEMBLY INSTRUCTIONS
1A
1B
16-1
16-2
1C
16-3
16-1
16-2
2
2A
16-3
16-4
16-4
2B
7

Publicidad

loading

Productos relacionados para Louisiana Grills 7 Serie

Este manual también es adecuado para:

Lgv7pc1190077765700