Cherubini RX MINI Instrucciones página 35

To enable (automatically) or disable (manually) the sun sensor refer to the instruction
manual provided with the sensor or the remote control you want to use.
TEST MODE FOR WINDTEC/WINDTEC LUX
This function is useful to check the correct communication via radio, and perform the
wind and sun function test.
To activate the TEST function, hold the SET button down for around 2 seconds, until
the awning opens for 10 seconds and closes briefly to confirm that the test mode is
activated. The Test function lasts for 3 minutes, during which the wind and light level
settings can be checked, without waiting for the activation times. After 3 minutes, the
WindTec sensor returns to normal mode function. During the wind-alarm the red led
inside the control unit is on.
WIND FUNCTION TEST (WINDTEC, WINDTEC LUX)
To avoid errors during the wind function test, it is suggested that the sunlight function
be deactivated. By spinning the anemometer fins, when the speed detected by the sensor
exceeds the threshold set, the motor will close completely the awning.
SUN FUNCTION TEST (WINDTEC LUX)
Make sure that the sunlight function is on. When the sensor detects a change in the
sunlight intensity, it opens the awning if brighter than the set point or closes it if weaker.
This test can be repeated several times to establish the desired automatic opening and
closing level according to the light.
ENABLE / DISABLE THE SUN SENSOR
(WindTec Lux)
set
2 sec
35