Broan B150H75NS Serie Manual De Usuario E Instalador página 11

3. CONNECTIONS
3.1 E C
LECTRICAL ONNECTION TO
Always disconnect the unit before making any connections. Failure to cut power could result in electrical shock or damage to the wall
control or electronic module inside the unit.
Never install more than one optional main wall control per unit. Make sure that the wires do not short-circuit between themselves or by
touching any other components on the wall control. Avoid poor wiring connections. To reduce the risk of electrical interference (noise),
do not run wall control wiring next to control contactors or near light dimming circuits, electrical motors, dwelling/building power or
lighting wiring or power distribution panel.
U
NIT
HD0491
Use the terminal connector included to perform the electrical connection for optional main wall control. Check if all wires are correctly
inserted in their corresponding holes in the terminal connector. Use screws to fi x wires in the terminal connector.
Once the wall control connections have been made, insert the terminal connector in the electrical compartment.
NOTE : For information about the operation of the wall control, refer to the corresponding Installation and User Guide, available at
www.Broan-NuTone.com.
3.1.1 E C
LECTRICAL ONNECTION TO
VC0241
3.1.2 E C
LECTRICAL ONNECTION TO
VC0242
O M W
PTIONAL AIN ALL
B V
OTTOM IEW
S , D A
PEED EHUMIDISTAT OR
12V
D-
D+
Gnd
A O M
DVANCED PTIONAL AIN
12V D- D+ Gnd
C
ONTROL
!
WARNING
CAUTION
T
ERMINAL
O M W
UTOMATIC PTIONAL AIN
12V
D-
D+
Gnd
W C
ALL ONTROL
12V D- D+ Gnd
11
C
ONNECTOR
C
ALL ONTROL