Nordcap CSC 052 E Manual De Instalacion Y Uso página 23

DESCRIPTION OF CONTROLS VERS. E
OPERATING METHODS
Preheating
• Switch on the appliance by pressing key A.
• Three dotted line will appear.
• To pre-heat, press key F and the display will show time infinite (INF).
• Press key I and select the temperature value required using keys D and E.
• Then press key B, START.
• The display will show always actual temperature chamber.
Keeping warm To keep warm only, one proceed in two ways:
• Switch on the appliance by pressing key A.
• Three dotted line will appear.
• Press key H (HOLD) and the display will show pre-set temperature.
• Select the temperature value required using keys D and E, then press key B, START for the start-up.
• The display will show always actual temperature chamber.
• Switch on the appliance by pressing key A.
• Three dotted line will appear.
• Press key F and the display will show time infinite (INF).
• Press key I and the display will show pre-set temperature.
• Select the temperature value required using keys D and E, then press key B, START for the start-up.
• The display will show always actual temperature chamber.
Cook & Hold with
• To cooking with timing, switch on the appliance by pressing key A.
timing
• Three dotted line will appear.
• Press key F and the display will show time infinite (INF).
• Select the time value required using keys D and E.
• Press key I and the display will show pre-set temperature.
• Select the temperature value required using keys D and E, then press key B, START for the start-up or
• Press key H (HOLD) and the display will show pre-set temperature.
• Select the temperature value required using keys D and E, then press key B, START for the start-up.
• The display will show always actual temperature chamber.
• To monitor the remaining time to cooking cycle, press key F.
• At the end of cooking cycle, a warning buzzer will activate and the oven will stop or automatically pass
Cook & Hold with
• To cook with core temperature probe, switch on the appliance by pressing key A.
core temperature
• Three dotted line will appear.
probe
• Press key G and the display will show core temperature probe pre-set.
• Select the temperature value required using keys D and E.
• Press key I and the display will show pre-set temperature.
• Select the temperature value required using keys D and E, then press key B, START for the start-up or
• Press key H (HOLD) and the display will show pre-set temperature.
• Select the temperature value required using keys D and E, then press key B, START for the start-up.
• The display will show always actual temperature chamber.
• To monitor core temperature probe, press key G.
• At the end of cooking cycle, a warning buzzer will activate and the oven will stop or automatically pass
set a subsequent holding cycle.
to the holding cycle if previously programmed.
set a subsequent holding cycle.
to the holding cycle if previously programmed.
WITH ELECTRONICAL CONTROL
DESCRIPTION OF CONTROLS
A. ON/OFF switch
B. START/STOP key
C. Display
D. Temperature increase key
E. Temperature decrease key
F. Time selection key
G. Core probe selection key
H. Keeping warm key
I. Temperature selection key
22
GB
Ed. 0117