Technical Data; Structure And Accessories; General View; Installation Of The Brush / Pad Holder / Pad Replacement - Nilfisk-Advance SD 400 Instrucciones De Utilizacion

SD 400 / SD 430 / SD 500 / SDP 430
2 _2

Technical data

Designation
Operating width
Operating height
Clearance height
Operating voltage
Rated output
Speed
Brush application pressure
Mains connection lead - length
Operating weight
Noise level
Table 1
2 _3

Structure and accessories

2 _3.1

General view

Picture 1
1 Handle height adjustment lever
2 Mains cable
3 Mains connection lead
4 Transport wheels
5 Appliance socket
6 Water supply hose
7 Bumper
8 Motorcover
9 Capacitor housing with appliance plug
10 Handle height adjustment lever
11 Handle top
12 Control lever for tank / spray unit
13 On / off lever
14 Safety catch levers
14
2 _2 Technical data / 2 _3 Structure and accessories
SD 400
mm 430
mm
mm
V/Hz 230/50
W 750
rpm 155
2
N/cm 0,42
m 12
kg 39
dB(A) 56
Subject to change without notice.
2 _3.2
Picture 1: Press handle height adjustment lever (1). Put
handle
backwards over the transport wheels (4). Line up the
catch plate of the brush or drive disc with the driver.
Turn brush or drive disc clockwise to lock.
Picture 2
When using a rubber-plate drive disc for thin pads a
floor pad on the ground and guide the machine into
position over the pad.
When using a drive disc with padholder-plate press a
pad onto the drive disc: fit the drive disc to the machine
and lift the machine into working position.
SD 430 SD 500
430 510
230/50 230/50
1100 1100
155 155
0,56 0,45
12 12
52 59
56 56
Installation of the brush / pad holder /
pad replacement
(10) into upright position.
Attention! When using a drive disc make
sure the machine is not started without a
floor pad under the disc.
SDP 430
430
230/50
1200
380
0,43
12
40
58
Tip machine