3.2 Delivery scope and transport inspection
The device includes the following components:
• WineDeluxe WD 24
• 3 x wooden shelf with ball bearing runners +
• 1 x wooden shelf
• Spare screws to change the direction in which the door opens
• Operating instructions
Scope of delivery for installation
1.
2 x mounting brackets
2.
2 x covers for the mounting brackets
3.
2 x spacers
4.
1 x Hinge cover PP1
5.
1 x Hinge cover PP2
6.
6 x screws
7.
1 x Wrench
8.
1 x Suction cup
9.
3 x cover profi les
1
3
6
7
9
PLEASE NOTE
Examine the shipment for its completeness and for any visible
damages.
Immediately notify the carrier, the insurance and the supplier
about any incomplete shipment or damages as a result of
inadequate packaging or due to transportation.
3.3 Unpacking
To unpack the appliance, proceed as follows:
•
Take the appliance out of the carton and remove the inter-
nal and external packaging material.
•
Always transport the appliance standing upright.
•
Do not tilt the appliance by more than 45 degrees as this
may damage the cooling system.
•
Clean the interior surfaces with lukewarm water using a soft
cloth.
•
Wait at least 24 hours before you plug the appliance into
mains power and turn it on. Only then should you place
wine bottles or beverages in the appliance.
PLEASE NOTE
Only remove the blue protective fi lm shortly before setting
up the device in the
location where it will be used, to prevent scratches and dirt
accumulations.
If possible, keep the original packaging for the device for the
duration of the guarantee period of the device, in order that
the device can be re-packaged properly in the event of a
guarantee claim.
2
4
5
8
WARNING
Warning! A non-installed appliance may tip over!
3.4 Setup location requirements
In order to ensure the safe and trouble-free operation of the de-
vice, the setup location must fulfi l the following prerequisites:
•
Only install your appliance in a piece of furniture which is
suitable for this purpose and can bear the weight of the appli-
ance even when completely full.
•
Locate the appliance away from direct sunlight and sources
of heat (stove, heater, radiator, etc.). Direct sunlight and
heat sources may adversely aff ect energy consumption and
cooling performance.
•
This unit is not designed for use in a garage or any other out-
side installation.
•
This cooling appliance is intended for ambient temperatures
of 16–38 °C.
WARNING
Fire hazard due to moisture!
If live parts or the power cord get wet, this can lead to short
circuits.
The appliance is intended for use in closed rooms. Do not
operate the appliance outdoors or in areas where it is expo-
sed to splashing water or moisture.
•
Do not set up the appliance in a hot environment or near
fl ammable material.
•
WARNING: Do not block the ventilation openings in the appli-
ance housing (and installation housing).
•
The power socket must be easily accessible so that the power
cord can be disconnected easily in case of an emergency.
•
For energy saving reasons please ensure that the door is
closed when the appliance is turned on.
3.5 Electrical connection
In order to ensure the safe and trouble-free operation of the de-
vice, the following instructions must be observed for the electrical
connection:
•
Connect the appliance to a properly installed power out-
let with electrical data corresponding to the rating plate's
specifi cations.
•
The connection between the device and the electrical network
may employ a 3 meter long (max.) extension cable with a cross-
section of 1.5 mm². The use of multiple plugs or gangs is prohi-
bited because of the danger of fi re that is involved with this.
•
Do not bend the power cord. Place the power cord in a way
so that you do not trip over it. Make sure that the power cable
is undamaged and has not been installed under or over hot
or sharp surfaces.
•
This unit is not designed to be installed in an RV or used with
an inverter.
!
CASO WineDeluxe WD 24
DE
EN
FR
IT
ES
NL
RUS
SE
PT
21