5.3.2 Setting light intensity
DE
The light intensity can be set at 4 levels. They are 25 %, 50 %,
EN
75 % and 100 %.
FR
1.
Turn the appliance on.
2.
The LED strips will light up.
IT
3.
Press the "Light" button for a few seconds.
4.
The appliance will briefl y peep once.
ES
5.
Briefl y press the "Light" button again to select the desired
NL
lighting level (L1 - L4).
RUS
5.4 How to turn off the sound
To switch off the sound of the appliance, press the right down
SE
arrow and the light key at the same time. You can also use this
PT
button combination to turn the sound back on.
5.5 Wi-Fi control
An app is available to control and programme the appliance
via Wi-Fi. To connect to the appliance simultaneously press the
"Light" and "On / Off " buttons. If you have started the „connec-
tion mode" by mistake, briefl y press the On / Off key. To use the
Wi-Fi mode download the CASO Control app to your smart-
phone or tablet. Visit our website www.casoapp.com/help for
details about the app, the range of functions and instructions
on how to install it.
6 Cleaning and Maintenance
This chapter provides you with important notices with regard to
cleaning and maintaining the device. Please observe the notices
to prevent damages due to cleaning the device incorrectly and to
ensure trouble-free operation.
6.1 Safety information
ATTENTION
Please observe the following safety notices, before you com-
mence with cleaning the device:
Prior to commissioning, clean the appliance thoroughly.
Turn the appliance off prior to cleaning, remove the plug
from the wall socket and remove all the bottles.
Do not clean the appliance with hard, scratchy or abrasive
cleaning agents such as steel wool or the like.
6.2 Cleaning
Interior
Clean the interior surfaces with lukewarm water, a soft cloth and
mild detergent. Use a soft cloth to dry the appliance thoroughly.
Door seal
To keep the appliance running effi ciently, make sure that the door
seal is kept clean. The door seal can be removed for cleaning with
a damp cloth.
Cabinet
The cabinet should be cleaned with a mild detergent and warm
water. Use a soft, damp cloth for drying.
Exhaust vent/ Ventilator
The exhaust vent may become blocked - e.g. by dust - thus impai-
ring the appliance's cooling effi ciency. If necessary, use a vacuum
cleaner to remove any blockage to the exhaust vent.
30
CASO WineDeluxe WD 24
7 Troubleshooting
This chapter provides you with important notices with regard
to operating the device. Observe the following notices to avoid
dangers and damages.
7.1 Safety notices
ATTENTION
Only qualifi ed electricians, who have been trained by the ma-
nufacturer may carry out any repairs on electrical equipment.
Improperly performed repairs may result in personal injury or
damage to the device.
7.2 Troubleshooting table
The following table assists in localizing and rectifying minor faults.
Fault
Possible cause
• Check the temperature control setting.
• External environment may require
another setting.
• The door is open too often.
Cooling perfor-
• The door is not fully closed.
mance is unsatisfac-
• The door seal does not seal properly.
tory.
• The wine cooler does not have suffi -
cient clearance.
• External environment may require
another setting.
The light does not
Contact our Customer Service.
work.
• Check that the appliance is standing
level.
Vibrations and/or
• The door does not close correctly.
the appliance is too
• The door was installed the wrong way
loud. The door does
round or incorrectly.
not close correctly.
• The seal is worn out. The shelves are out
of position.
No running noises
The compressor does not start when the
can be heard (com-
ambient temperature is lower than the
pressor).
desired temperature.
The sound of the compressor when it
Gurgling sound of
starts or stops. The sound of refrigerant
liquid.
fl owing through the refrigeration system.
Automatic door
Remove the seal and knead it. Replace
opener does not
the seal.
work.
Error code H1 and
The door has been open for more than 1
appears in the
minute. Temperature loss in the interior.
display
Error code H2 and
Temperature sensor error – Contact our
appears in the
Customer Service.
display
Refrigerant leak - Contact our Customer
Error code H3
Service.
Faulty compressor performance – Con-
Error code „–"
tact our Customer Service.
There is a Wi-Fi connection to the Wi-Fi
Error code CE1
module but no connection to the Internet.
DNS error – there is a Wi-Fi connection
Error code CE2
to the router but no connection to the
Internet server.
Error code CE3
CASO Cloud Server is unavailable.
Error code CE4
Wi-Fi not found, signal could be too weak
Error code CE5
Update server is unavailable