Sony Trinitron CPD-520GST Manual De Instrucciones página 19

Power Saving Function
This monitor meets the power-saving guidelines set by
E S
VESA and NERGY TAR, as well as the more stringent
NUTEK .
If the monitor is connected to a computer or video graphics
board that is VESA DPMS (Display Power Management
Signaling) compliant, the monitor will automatically reduce
power consumption in three stages as shown below.
Power consumption
mode
Normal operation
1
Standby (1st mode)
2
Suspend (2nd mode)
3
Active-off (3rd mode)
4
Power-off
5
Displaying the Monitor's
Information Box
You can display the model name, serial number and year of
manufacture using the monitor's INFORMATION OSD.
Press and hold the MENU button for 5 seconds.
The INFORMATION OSD appears.
Example:
MENU
The INFORMATION OSD includes the model name, serial
number, manufactured year, and manufactured week.
The OSD automatically disappears after about 30 seconds.
Damper Wires
When viewing a white background, very thin horizontal lines
may be visible on the screen as shown below. These lines are
the shadows of the damper wires and are characteristic of
CRTs that use aperture grilles. The wires are attached to the
aperture grille on the inside of the Trinitron tube and prevent
the vibration of the aperture grille.
Damper wires
Vertical
Screen Horizontal
sync signal
sync signal
present present
active
present
blank absent
absent
blank present
absent
blank absent
—
—
—
INFORMATI ON
MODEL : CPD 520GST
SER NO : 1234567
MANUFACTURED :1998 52
Getting Started
You can set the delay time before the monitor enters the
power saving mode using the OSD. Set the time according
to "Setting the power saving delay time" on page 16.
Note
If no video signal is input to the monitor, the "NO INPUT
SIGNAL" message (page 20) appears. After the delay time has
passed, the power saving function automatically puts the monitor
into the active-off mode and the u indicator lights up orange. Once
the horizontal and vertical sync signals are detected, the monitor
automatically resumes its normal operation mode.
Power consumption
Recovery time
≤ 160 W
—
≤ 100 W
Approx. 3 sec.
≤ 15 W
Approx. 3 sec.
≤ 5 W
Approx. 10 sec.
—
0 W
Plug & Play
This monitor complies with the DDC™1, DDC2B, DDC2AB
and DDC2B+ Display Data Channel (DDC) standards of
VESA.
When a DDC1 host system is connected, the monitor
synchronizes with the V. CLK in accordance with the VESA
standards and outputs the EDID (Extended Display
Identification Data) to the data line.
When a DDC2B, DDC2AB or DDC2B+ host system is
connected, the monitor automatically switches to the
appropriate standard.
DDC™ is a trademark of the Video Electronics Standard
Association.
Note
®
When using Windows 95, the DDC standard does not apply to the
5 BNC connectors. If you use the DDC standard, connect the HD15
connector to the computer with the supplied video signal cable.
Technical Features
u indicator
Green
Green and orange
alternate
Green and orange
alternate
Orange
Off
19
EN
F
ES
C