Dolmar AM-3738 Manual De Instrucciones página 12

TROUBLE SHOOTING
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual,
do not attempt to dismantle the tool. Instead, ask Dolmar Authorized Service Centers, always using Dolmar
replacement parts for repairs.
Malfunction status
Mower does not start.
Motor stops running after a little use.
It does not reach maximum RPM.
Cutting tool does not rotate:
stop the machine immediately!
Abnormal vibration:
stop the machine immediately!
014546
OPTIONAL ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Dolmar tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Dolmar service center.
• Blade
• Makita/Dolmar genuine battery and charger
NOTE:
• Some items in the list may be included in the tool
package as standard accessories. They may differ from
country to country.
Noise
The typical A-weighted noise level determined according
to EN60335-2-77:
Sound pressure level (L
Sound power level (L
Uncertainty (K): 3 dB (A)
Wear ear protection
12
Two battery cartridges are not
installed.
Battery problem (under voltage)
The lock key is not inserted.
Battery's charge level is low.
Cutting height set is too low.
Battery cartridge is installed
improperly.
Battery power is dropping.
The drive system does not work
correctly.
Foreign object such as a branch is
jammed near the blade.
The drive system does not work
correctly.
Blade is imbalanced, excessively or
unevenly worn.
ENG905-1
): 81 dB (A)
pA
): 93 dB (A)
WA
Cause
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60335-2-77:
Vibration emission (a
Uncertainty (K): 1.5 m/s
• The declared vibration emission value has been
measured in accordance with the standard test method
and may be used for comparing one tool with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the power
tool can differ from the declared emission value
depending on the ways in which the tool is used.
• Be sure to identify safety measures to protect the
operator that are based on an estimation of exposure in
the actual conditions of use (taking account of all parts
of the operating cycle such as the times when the tool
is switched off and when it is running idle in addition to
the trigger time).
EC DECLARATION OF CONFORMITY
For European countries only
The EC declaration of conformity is included as Annex A
to this instruction manual.
Action
Install the charged battery cartridges.
Recharge the battery cartridge. If
recharging is not effective, replace
battery cartridge.
Insert the lock key.
Recharge the battery cartridge. If
recharging is not effective, replace
battery cartridge.
Raise the height.
Install the battery cartridge as
described in this manual.
Recharge the battery cartridge. If
recharging is not effective, replace
battery cartridge.
Ask your local authorized service
center for repair.
Remove the foreign object.
Ask your local authorized service
center for repair.
Replace the blade.
2
): 2.5 m/s or less
h
2
ENG900-1
ENG901-1