Descargar Imprimir esta página

MiLECTRIC RCM-355X Manual De Instrucciones página 39

Ocultar thumbs Ver también para RCM-355X:

Publicidad

Idiomas disponibles

Idiomas disponibles

Door reversal instructions
Note: Ensure that the rubber gaskets seal tightly
around the perimeter of the door before tightening
the hinge screws.
1. Unscrew the door hinge cover
and remove the door hinge
cover.
2. Unplug the cable.
Unscrew the 4 screws holding
the upper hinge and remove it.
Remove the ground wire loop
from the hinge.
Insert the cable connection into
the opening at the top of the
appliance Remove the door
stopper and small end caps
cover.
3. Fit the door connector and
cable connection into the door
opening and then fit the small
end cap.
4. Loosen 1 screw as shown in
the figure below, to remove the
recess cover on the top of the
appliance Remove the cover
from the small end cover of the
door and pull out the door plug
and cable connection.
5. Place the door socket door
into the round opening opening
of the door and fit the cover of
the small end cap.
6. Lift the refrigerator door
about 50 mm to remove it from
the appliance.
7. Loosen the 3 screws holding
the middle hinge and then re-
move it.
8. Lift the freezer door about 50
mm so that it can be removed
from the refrigerator.
9. Remove the adjustable front
brackets under the bottom hin-
ge. Then, loosen the 4 screws
holding the lower hinge and
remove it from the refrigerator.
10. Install the removed parts on the opposite side of
the appliance. Pull the plug from the door, as shown
in the figure below, and install it in the respective
position on the other side.
11. Remove the screws from the stop, as shown in
the figure below, and install it on the opposite side
of the door.
12. Remove the shaft from the
lower hinge stops and install it
as shown in the picture below.
13. Install the doors on the oppo-
site side.
Remove the adjustable bracket
at the front, as shown below.
Then, install the bottom hinge on
the other side of the refrigerator
and tighten the screws.
14. Adjust the adjustable feet
15. Position the freezer door,
rotate the middle hinge 180° and
then install it on the opposite
side of the appliance. Secure the
middle hinge with the 3 corres-
ponding screws 16. Repeat the
previous step for the refrigerator
door.
17. Install the recess cover on the
opposite side of the appliance
and tighten the screw.
Finally, check that the doors are correctly aligned
and close properly.
41
English
milectric.com

Publicidad

loading

Este manual también es adecuado para:

Rcm-354b84456390003048445639000397