Publicidad
Idiomas disponibles
Idiomas disponibles
ENgLish
WARNING: To reduce the risk of injury, read the pressure washer instruction manual and the engine instruction manual
before operating pressure washer.
A install the handle
Slide the handle assembly onto the frame, align holes, insert saddle bolts and secure
in place with knobs. Tighten until snug.
B Add/Check Oil
The engine is shipped without oil. Before starting engine, add the oil provided.
Check oil level prior to each use. Refer to Engine Owner's Manual for
complete procedure.
C Add gasoline
In a well ventilated outdoor area add fresh, high quality, unleaded gasoline with
a pump octane rating of 86 or higher. Do not overfill. Wipe up spilled fuel before
starting the engine. Refer to Engine Owners Manual for complete procedure.
IMPORTANT: Ethanol Shield
problems in power equipment. Follow the instructions on the container and add to the gasoline.
DANGER:
•
Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an
odorless and deadly gas.
•
Risk of fluid injection and laceration. When using the high-pressure setting, DO NOT allow the high-pressure spray to
come in contact with unprotected skin, eyes or with any pets or animals. Serious injury will occur.
WARNING: Do not allow the unit to run for more than two minutes without the gun trigger being pulled. This
could cause overheating and damage to the pump. When the temperature inside the pump rises too high, the
thermal relief valve will open and release a spray of water from the pump to lower the internal temperature.
The valve will then close.
1 Connect garden hose to Pump
Thread the garden hose to the
pump inlet.
4
QUICK SETUP GUIDE
(sold separately) is a fuel stabilizer that helps eliminate and prevent ethanol related
™
QUICK START GUIDE
2 Connect high Pressure hose
to Pump
Connect the high pressure hose to the
pump outlet.
3 Connect high Pressure hose
to spray gun
Connect the other end of the high
pressure hose to the spray gun.
Publicidad
