Descargar Imprimir esta página

THOMSON SB402BT Manual De Instrucciones página 13

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 24
Getting started
Safety warning and notice
Contents of the box
Description of parts
Discover your remote control
TV Connection
Bluetooth operation
USB operation
Getting started
Take the device out of the box.
Remove all the packaging from the product.
Place the packaging inside the box or dispose of it safely in compliance with the waste
sorting instructions shown on the outside.
Safety warning and notice
You must read and understand all the instructions before using this device. The warranty will
not apply if damage is caused by failure to follow the instructions.
1. Never remove the device casing.
2. Never place this device on top of other electrical equipment.
3. Protect the power cord from being stepped on or pinched, particularly at the
plugs, sockets, and the point where it exits the device. Make sure that the
power rating corresponds to the voltage shown on the rating plate at the
rear of the device. Always pull the plug from the socket when disconnecting
from the mains. Never pull on the cord. Ensure you have completed all the
other connections before connecting the mains plug.
4. Only use attachments/accessories that are recommended by the
manufacturer.
5. Entrust all device repairs to qualified repairers. Repair is needed when the
device has been damaged in any fashion, and in particular:
- if the power cord is damaged;
- in the event of a liquid spill or objects being inserted into the device;
- if the device is exposed to rain or dampness;
- if the device does not operate normally;
- or if the device has been dropped or impacted.
6.
The series panel is located on the bottom of the device.
7.
Never block the air vents.
8.
Make sure you have enough space for ventilation. Place the product on a stable surface.
9.
This device must be used in a moderate climate, away from direct sunlight, naked flames
or sources of heat, heaters, cookers or any other devices (including amplifiers) that
generate heat. Do not install near a heat source.
10. The batteries (battery pack or inserted batteries) must not be exposed to excessive heat,
such as sunshine, fire, etc.
13
Troubleshooting
13
Warning about batteries
15
Device technical specifications
15
Technical specifications of the adapter
16
Environmental protection
17
Additional information
17
Declaration of conformity
18
- EN 13 -
18
19
20
20
21
21
21

Publicidad

loading