Publicidad
Idiomas disponibles
Idiomas disponibles
USING THE ALARM
4. Emergency deactivation
Note: Requires the connection of the white wire (+12V APC) and the blue wire (perimetry).
Open a door (if perimeter connected) or ground the BLUE wire.
Switch the ignition from ACC ON to ACC OFF 5 times, then stay in the ON position. The siren beeps 3 times to indicate deactivation.
5. Shock Sensor Sensitivity Adjustment
The sensitivity of the shock sensor can be adjusted in 5 levels. 1 = Shock sensor disabled, 5 = Maximum sensitivity. By default, the
shock sensor is set to level 3.
To adjust the sensitivity of the shock sensor, press button
programming mode.
•
To lower the sensitivity of the sensor, press button
•
To increase sensor sensitivity, press button
To exit settings mode, do not touch the remote control for 10 seconds. The siren beeps 3 times to indicate exit from programming mode.
6. Activation/Deactivation of the current consumption sensor
To access the current consumption sensor settings, press button
entered programming mode.
•
To activate the current consumption sensor, press button
•
To deactivate the current consumption sensor, press button
To exit settings mode, do not touch the remote control for 10 seconds. The siren beeps twice to indicate exit from programming mode.
#3
for 2 seconds. The siren will beep 5 times to indicate you have entered
#3
as many times as desired.
#1
as many times as desired.
#1
#3
once. The siren then beeps once in response.
#1
once. The siren then beeps twice in response.
18
for 2 seconds. The siren will beep 3 times to indicate you have
Publicidad
