Seca 675 Manual De Instrucciones Y Garantía página 22

Wall bracket
– Place the desk-top stand on the display
casing from underneath.
The narrow side must be located at the
top of the display. The desk-top stand
locks in position.
– Fit the wall bracket to the wall at the de-
sired height.
– Push the display casing onto the wall
bracket.
Power supply
The scale is powered by a mains unit.
Please use only the mains unit sup-
plied or mains units from the seca
range of accessories. Before plugging
the unit into the socket, check whether
the mains voltage marked on the
mains unit matches local mains volt-
age.
4. Setting up and aligning the scale
– Place the scale on a level surface.
– Undo the locknuts using the four foot
screws (1).
– Align the scale by undoing the foot
screws. The air bubble in the spirit level
must be right in the centre of the
circle (2).
– Then re-tighten the locknuts (3).
– Ensure that only the feet of the scale are
in contact with the floor. The scale may
not be in contact at any other point.
Important!
The alignment of the base of the scale must be checked and corrected if neces-
sary every time the location of the scale is changed.
22
3 .
1 .
2 .
spirit level
Libelle