Seca 675 Manual De Instrucciones Y Garantía página 30

6. Storing the scale
The scale can be stored upright to save space. Secure the scale so that it does not fall
over when stored in the upright position.
– Remove the mains unit plug from the
mains socket.
– Remove the mains unit plug from the
connecting socket on the scale.
– Press the locking mechanism on the
Western plug and remove the plug from
the socket on the electronics box.
– Carefully pick up the scale by the handle
and move it using the castors on the
other side of the scale.
7. Cleaning
Clean the rubber surface and the housing as required using a domestic cleaning agent or
commercially-available disinfectant. Follow the manufacturer's instructions.
Under no circumstances use abrasive or acid cleaners, white spirit, benzene or the like for
cleaning. Such substances can damage the high-quality surfaces.
8. What do I do if...
... no weight display comes on?
– Is the scale switched on?
– Is the plug contact of the mains unit properly connected to the scale?
– Is the plug contact for connecting the display to the scale correctly connected?
0. 0
... does not appear before weighing?
– Press the Start key again – there must not be any load on the scale – and only its feet
should be in contact with the floor.
... one segment is illuminated constantly or not at all?
– The relevant segment has a fault. Inform Servicing.
... St0p appears in the display?
– Maximum load has been exceeded.
... the display flashes?
– If you have just activated the Hold or Tare function, please wait until the scale has de-
tected a steady weight value. The display will then stop flashing.
– If there has been no activation of a function beforehand, remove the load from the scale
and wait until
0. 0
30
is displayed, then weigh again.