Publicidad
Idiomas disponibles
Idiomas disponibles
GB
5. Fasten the quick-release lever (4a) by
pushing it in the direction of the midd-
le bar (5).
6. Repeat the installation process for the
second middle bar.
Mounting the handlebar:
1. Suspend the mains cable strain relief
(
15) from the handlebar (
2. Place the handlebar (
middle bars (5).
3. Guide the screws (4c) from the inside
through the holes of the middle bar (5)
and handlebar (
4. Place the washers (4b) onto the
screws (4c).
The smooth side of the washer should
point towards the quick-release lever;
the grooved side should point towards
the device.
5. Turn the quick-release levers (4a)
onto the screws (4c).
6. Fasten the quick-release levers (4a)
by pressing them in the direction of
the handlebar (
7. Fasten the device cable (14) to the bar
using the device cable terminals (13).
Mounting and emptying
the collection bag
WARNING: Never operate the
implement without the impact
protector. Danger of Injury!
The collection bag is recommended
for operation with the air roller
(
16)!
The collection bag is delivered in a folded
state and must be assembled before be-
ing placed into the device.
34
3).
3) on the
3).
3).
Assembling the collection bag:
1. Pull the collection bag (11) over the
collection bag rod (19).
The handle (20) of the collection bag
rod (19) is located outside the collecti-
on bag (11).
2. Put the 6 plastic straps (21) of the
collection bag (11) over the collection
bag rod (19) and clip in the plastic
straps (21).
Attaching the collection bag to the
device:
1. Lift the impact protection flap (12).
2. Suspend the pins (22) on the collec-
tion bag rods (19) from the recep-
tor (23) on the device housing (
3. Release the impact protection flap (12)
so that it holds the collection bag (11)
in position.
Removing/emptying the collection bag:
1. Lift the impact protection flap (12) and
remove the collection bag (11).
Operation
Please observe local regulations
concerning noise protection.
Setting the working positions
The implement has 5 principal position
settings:
+10 mm : Transport position
This position sets the maximum safety
spacing between the tool and the floor.
-3 mm : Working position
Set this position when working with a new
implement.
8).
Publicidad
