Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance and care
7.1.5 GUIDING SHAFT
Keep guiding shaft free of dirt.
Grease if necessary the upper and lower range of the guiding
shaft (see arrows).
The manufacturer of the device does not take over any adhesion for malfunctions, which
are to due to maintenance periods not taken place, rough contamination and
maintenance lacking.
7.2
Trouble shooting
ERROR
The clamping-power is not big
enough, the load is slipping out
(optional)
(optional)
(Adjustment of the gripping range)
(optional)
(Property of material)
Unbalanced load
(Adjustment of the gripping range)
(optional)
Automatic release does not work
mechanical (optional)
54000046
Guiding shaft
CAUSE
The grippers are worn
The maximum load is exceed
The actual opening width is not
correct
The surface of the material is dirty or
the material is not suitable / allowed
for this device.
The device is not loaded
symmetrically
The adjustment of the gripping range
is not symmetrical.
Automatic release does not work
27 / 29
REPAIR
Replace the grippers
Reduce the weight of. the load
Adjust the gripping range according
to the load you want to transport
Check the surface of the material or
ask the manufacturer, if you the
material is allowed for this device.
Adjust the position of the load
Correct the adjustment of the gripping
range
Clean automatic release with high
pressure-cleaner
Correct faulty switching (→see
chapter "Picture of the automatic
release")
Change the inset of the automatic
release
GB
Publicidad
