LG WCES6428 Serie Manual De Instalación página 12

en-us_main.book.book Page 12 Wednesday, February 8, 2023 9:09 AM
12 INSTALLATION
e
Green (or bare) ground wires
f
4-wire flexible conduit from oven
1
Separate the oven ground and white wires if
necessary.
2
Connect the oven ground (green) wire to the
branch circuit ground (green) wire in
accordance with local codes, using a wire nut.
3
Connect the oven white wire to the branch
circuit neutral (white or gray) wire in
accordance with local codes, using a wire nut.
4
Connect the oven red wire to the branch
circuit red (L2) wire in accordance with local
codes, using a wire nut.
5
Connect the oven black wire to the branch
circuit black (L1) wire in accordance with local
codes, using a wire nut.
6
Install the junction box cover.
Installing Oven and Assembling
Oven Doors and Bottom Decorative
Trim
Installing the Oven
Install the oven into the cabinet as follows:
1
Use caution when lifting the oven and wear
gloves to protect hands from any sharp
edges.
2
Use two or more people to lift or move the
oven into the cabinet opening.
• Loop (do not tie) a 36" (91 cm) string around
the conduit before the oven is slid into
place. Lay the string over the top of the
oven and use it to keep the conduit from
falling behind the oven.
• Lift oven into cabinet cutout using the oven
opening as a grip. Carefully push against
the oven front frame. Do not push against
outside edges.
• While sliding the oven back, pull the string
so that the conduit lies on the top of the
oven in a natural loop.
• When you are sure the conduit is out of the
way, slide the oven 3/4 way back into the
opening. Remove the string by pulling on
one end of the loop.
3
Secure the oven.
• Using the mounting holes
side trim as a guide, drill pilot holes for
screws provided. (For securing the oven,
use a minimum of 4 screws, one on each
side in both the upper and lower ovens.)
• Secure the oven to the cabinet with screws
provided. If the cabinet is particle board,
you must use 3/4" particle board screws.
These may be purchased at any hardware
store.
Assembling Oven Doors
1
Firmly grasp both sides of the door at the top.
2
With the door at the same angle as the
removal position, seat the indentation
a
the hinge arms into the bottom edge of the
b
hinge slots . The notch in the hinge arms
must be fully seated into the bottom edge of
the slots.
a
on the oven
c
of