en-us_main.book.book Page 13 Wednesday, February 8, 2023 9:09 AM
3
Open the door fully. If the door will not open
fully, the indentation is not seated correctly in
the bottom edge of the slots.
4
Lock the hinge locks
toward the slots in the oven frame until they
lock.
5
Close the oven door.
a
Bottom vent trim
NOTE
• When you install the oven door, be careful not to
bump the bottom vent trim.
• Keep oven vents unobstructed. Replace the
bottom vent trim if it becomes bent or
deformed. Never block the vent with plastic or
heat-sensitive items.
Assembling the Bottom Decorative
Trim
a
Bottom decorative trim
• After installing the oven in the cabinet, assemble
bottom decorative trim with 2 screws
Test the Oven Before Use
Each of the functions has been factory checked
before shipping. However, it is suggested that you
d
, rotating them back
b
(4X10).
verify the operation of the oven once more. Refer
to the Owner's Manual. Follow the instructions for
the basic check.
• Turn on power supply. The initial signal sound is
heard and the Clock segment appears in the
display.
NOTE
• Depending on the model, some of the following
functions may not be available.
Common
1
Turn on the power supply. The initial signal
sound will be heard.
2
Check the operation of the broil mode.
• When the oven is set to broil, the upper
element in the oven should become red.
After a few minutes, partially open the oven
door. You should feel heat from the oven.
Touch Stop.
3
Check the operation of the convection bake
mode.
• After setting the oven to 350 ℉ / 177 ℃ for
convection baking, the fan inside the oven
should come on with the door closed. Touch
Stop.
4
Check the operation of the bake mode.
• After setting the oven to 350 ℉ / 177 ℃ for
baking, the temperature of the oven in the
display should increase. Touch Stop.
5
Turn on and off the oven light to check that
the lights are in normal condition.
Upper Oven
1
Place a glass bowl filled with water in upper
oven.
2
Turn the microwave on for 1 minute. The
water should be hot.
3
Touch Stop.
INSTALLATION
13