LD Systems CURV 500 I AMP Manual De Usuario página 10

EXIT
To exit the selection menu and show the main display, turn the MENU dial to EXIT (light background) and confirm by pressing the MENU dial.
BRIDGE MODE / 70 V OPERATION
To set up a 70 V installation with the CURV 500 I AMP and CURV 500 satellites you require the LD Systems SmartLink adapter for 70 V applications
LDCURV500SLAT (available in black and white, please note the instructions in the user manual for the LDCURV500SLAT); if you wish to use the
speakON-compatible speaker output of the CURV 500 I AMP you require speaker cables with specially configured speakON-compatible plugs, since
two amplifier channels can be connected simultaneously in bridge mode in conjunction with the relevant speaker preset. As an alternative to
speakON-compatible plugs, you can use terminal block connectors (supplied, for configurations see diagram CONFIGURATION OF SPEAKER OUTPUTS
or label on the amplifier, recommended for speaker cables 2 x 1.5 mm²). Select the preset corresponding to the number of satellites per SmartLink
adapter as described under PRESET, then connect the CURV 500 I AMP and the CURV 500 SLAT SmartLink adapter. It is advisable not to combine
SmartLink adapters with differing numbers of satellites due to the different preset settings. The maximum number of SmartLink adapters connected
per bridge channel is derived from the number of CURV 500 satellites per SmartLink adapter.
Examples:
1 CURV 500 satellite per SmartLink adapter 70 V = maximum
of 24 SmartLink adapters (24 x 20 W = 480 W max.)
Speaker preset 1xC500-70V
2 CURV 500 satellites per SmartLink adapter 70 V = maximum
of 12 SmartLink adapters (12 x 40 W = 480 W max.)
Speaker preset 2xC500-70V
10
1 24
1 12
1 x LDCURV500SAT
LDCURV500SLAT
2 x LDCURV500SAT
LDCURV500SLAT