Fanimation The Louvre MAD3255 Serie Manual Del Propietário página 6

How to Assemble Your Ceiling Fan (cont'd)
4. Route wires through motor coupling cover,
canopy screw cover and ceiling canopy. (Figure 4)
5. Reinstall the hanger ball on the downrod as
follows. Route the three 80 in. Wire through the
hanger ball. Position the pin through the two holes
in the downrod and align the hanger ball so the
pin is captured in the groove in the top of the
hanger ball. Pull the hanger ball up tight against
the pin. Securely tighten the set screw in the
hanger ball. A loose set screw could create fan
wobble. (Figure 5)
6. Cut off excess lead wire approximately 6 to 9
inches above top of the top of the downrod. Strip
insulation off 1/2 inch from the end of each lead
wire. (Figure 6)
NOTE: All set screws must be checked, and retightened
where necessary, before installation.
Ceiling
Canopy
Motor
Coupling
Cover
6
Canopy Screw
Cover
Figure 4
Figure 5
Figure 6