Publicidad
Idiomas disponibles
Idiomas disponibles
ELECTRICAL CONNECTION
WARNING: Electrical Shock Hazard
•
Failure to follow these instructions can result in death, fire, or electrical shock.
•
Electrical connection must be performed by a qualified service technician in accordance with the kit
instructions and all local codes and requirements.
•
DO NOT use an adapter.
•
DO NOT use an extension cord.
This appliance is not supplied with a plug and needs to be
connected directly to the electrical mains.
If you wish to install this appliance with a plug, it must be installed
by a qualified technician. The plug must be a 4-prong, 3-phase
power plug that is designed specifically for ranges and ovens.
Electrical Requirements: 220-240V/50-60Hz. With
recommendation to connect to a 50 Amp power supply.
WARNING: BEFORE MAKING THE ELECTRICAL CONNECTION, MAKE SURE THAT:
•
The safety circuit-breaker and the electrical system are able to withstand the load of the appliance.
Refer to rating label on back of range.
•
Rating plate is located on back of range should you need to verify any of the electrical requirements.
•
The power supply system has a ground connection in good working order in accordance with the
regulations in force.
•
The electrical socket is easily accessible with the appliance installed. In all cases, the power supply lead must
be positioned so that it does not reach a temperature of 122°F above the room temperature at any point.
•
The manufacturer is not liable for any direct or indirect damage caused by faulty installation or
connection. It is therefore necessary that all installation and connection operations are carried out by
qualified personnel complying with the local and general regulations in force.
ELECTRICAL CONNECTION
Follow these steps for the 3-wire and 4-wire installation
process.
1.
Remove the wire cover on the back of the range
by removing the two (2) screws using a Phillips
screw driver. (Refer to Figure 7.)
NOTE: DO NOT discard these screws.
2.
Remove the knockout ring (1-3/8") located on
bracket directly below the terminal block. To
remove the knockout, use a pair of pliers to bend
the knockout ring away from the bracket and twist
until ring is removed. (Refer to Figure 8.)
3.
Assemble the strain relief in the hole. Insert the
power cord through the strain relief and tighten.
Allow enough slack to easily attach the cord
terminals to the terminal block. If tabs are present at
the end of the winged strain relief, they can be
removed for better fit. (Refer to Figure 8.)
Oven Light
Upper Heating Element
Bottom Heating Element
Convection Heating Element 1800 W
Ventilator Motor
Cooling Fan
Terminal
Block
Strain Relief
14
Electrical Specifications
System
Wattage
25 W
1300 W / 1000 W
1000 W
23 W
18 W
Terminal
Block Cover
Figure 7
Figure 8
Knockout
Ring
Bracket
Publicidad
