Maintenance Interval - Dolmar ET-71 C Manual De Instrucciones

MAINTENANCE INTERVAL

Parts:
Power cord
Auxiliary handle screw
Cutting tool guard
(protector)
Nylon cutting head
TROUBLESHOOTING
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual, do
not attempt to dismantle the tool. Instead, ask Dolmar Authorized Service Centers, always using Dolmar replacement
parts for repairs.
Malfunction status
Motor does not run.
Motor stops running after a little use.
It does not reach maximum RPM.
Cutting tool does not rotate:
stop the machine immediately!
Abnormal vibration:
stop the machine immediately!
Cutting tool and motor cannot stop:
Disconnect the mains immediately!
OPTIONAL ACCESSORIES
CAUTION:
• These accessories or attachments are recommended
for use with your Domar tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Dolmar Service
Center.
• Nylon cutting head
• Nylon cord (cutting line)
• Shoulder harness
Interval:
Every time before use
Every time before use
Every time before use
Every 10 h
Cause
Power mains is not plugged in.
Power cable broken.
The drive system does not work
correctly.
Overheating.
The drive system does not work
correctly.
Foreign object such as a branch is
jammed between the guard and the
nylon cutting head.
The drive system does not work
correctly.
One end of the nylon cord has been
broken.
The drive system does not work
correctly.
Electric or electronic malfunction.
Visually inspect whether it is not badly worn or damaged.
If it is damaged, ask your local service center for repair.
Check whether screw is not loose. Tighten the screw if it
is loose. Replace the screw if it is damaged.
Check whether screw is not loose, whether protector is
not damaged. Tighten the screw if it is loose. Replace the
protector if it is damaged.
Visually inspect whether it is not badly worn or damaged.
If it is damaged, replace it.
Plug in the mains.
Ask your local authorized service
center for repair.
Stop using of tool to allow it to cool
down.
Ask your local authorized service
center for repair.
Remove the foreign object.
Ask your local authorized service
center for repair.
Bump the nylon cutting head against
the ground while it is rotating to
cause the cord to feed.
Ask your local authorized service
center for repair.
Disconnect the mains and ask your
local authorized service center for
repair.
NOTE:
• Some items in the list may be included in the tool
package as standard accessories. They may differ from
country to country.
How to:
Action
11