Fanimation The Celano v2 FP8062 Serie Manual Del Propietário página 13

How to Assemble Your Light Kit (continued)
3. Assemble the LED assembly to the light plate
assembly using the two key slots and replace the
third screw and securely tighten all three screws.
(Figure 3 )
4. Secure the glass to the LED assembly by twisting
in a clockwise direction. Do not over-tighten. (Figure 4)
How to Operate Your Remote Control
IMPORTANT:
1. Using a full range dimmer switch
(not included) to control fan speed will damage the fan.
To reduce the risk of fire or electrical shock, do not use
a full range dimmer switch to control the fan speed.
(Figure 1)
2. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
WARNING
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
Light Plate
Assembly
Glass
For illustrative purposes only-not
intended to cover all types of controls
13
LED Assembly
Figure 3
Figure 4
Figure 1
MAIN FUSE BOX
Figure 2