Publicidad
Idiomas disponibles
Idiomas disponibles
4
IMPORTANT
IF THE POWER GOES OUT, THE FIXTURE WILL MAINTAIN PREVIOUS SETTINGS, SO
THERE IS NO NEED TO GO UP THE LADDER TO ADJUST.
If fixture has had continuous power, to switch to manual mode follow below steps.
STEP 1
ON
OFF
2 Seconds
If power has been interrupted, must turn on to warm it up for 20 - 30 seconds.
STEP 1
Turn on for
20-30 secs.
ON
to warm up
sensor
OFF
IMPORTANT
LIGHT IS DETECTED, IT WILL ALLOW THE MOTION SENSOR TO RETURN TO CONTROLLING THE FIXTURE
THE NEXT DAY.
IMPORTANT
ACTIVATE REGARDLESS OF TIME OF DAY. HOWEVER, THIS PROCESS MUST BE RESET EACH DAY AFTER
DUSK TO DAWN FEATURE CYCLES THE PREVIOUS DAY'S MANUAL OVERRIDE CYCLE OFF.
10
Customize Settings (cont'd.)
COLOR TEMPERATURE SETTINGS
To change the white color of the light, rotate the "Color
Temperature" dial to the preferred setting:
3000K Warm white
4000K Bright white
5000K Daylight white
Rotate the COLOR TEMPERATURE control knob to either 3000K,
4000K, or 5000K to set the light color.
POWER OUTAGE
Manual Override
Switch the
power OFF
ON
and then
ON within
OFF
2 secs.
STEP 2
2 Seconds
THE SECURITY LIGHT WILL REMAIN ON UNTIL THE INTERNAL
DUSK-TO-DAWN SENSOR DETECTS THE NEXT DUSK-DAWN CYCLE. ONCE
MANUAL OVERRIDE ALLOWS THE LIGHT TO TURN ON AT ANY TIME, BY
OVERRIDING ALL SENSOR CONTROLS. IT ENABLES THE LIGHT TO
Switch the
power OFF
ON
ON
and then
ON within
OFF
OFF
2 secs.
Publicidad
