Good Earth Lighting SE1293-WH3-02LF0-G Manual Del Usuario página 8

The fixture has a built-in light sensor that prevents the motion sensor or area light from
activating during daylight hours. Once the power has been turned on, the fixture needs
around 20 seconds to warm up. The light will turn o after around 20 seconds, then the light will
go to the SetToGo factory presets (50ft. detection range, 3 minute light activation, 5000K color
temperature and the Area Light setting will be o ).
Set to
If these settings are acceptable for your needs, you don't need to do anything more with the SetToGo
settings except to do the actual electrical installation of the fixture.
ATTENTION!
1
VERIFYING RANGE SETTING
To confirm the set distance, perform a "walk by test." Walk straight across the
sensor field at the approximate distance set on the RANGE control knob.
IF THE TEST FAILS, try adjusting the sensor head toward the detection zone.
Sensor head can be adjusted either up, down, left, or right.
8
How the Controls Work
FACTORY PRESETS
Set-to-Go: The security light is PRESET at the factory with
the following settings:
Range: 50 feet
Minutes: 3 min.
(duration)
Color Temp.: 5000K Daylight white
Area Light: OFF
To change the factory SetToGo default settings, follow the
instructions below.
Customize Settings
SECURITY LIGHT SENSOR RANGE SETTINGS
To change the sensitivity of the PIR distance sensing, rotate the
"Range" dial the preferred setting:
5Ft: 5 feet, short range
30Ft: 30 feet, average range
60Ft: 60 feet, long range
Max.: Up to 100 feet, extra long range
Rotate the RANGE control knob to any of the marked presets: 5Ft. to Max.
(~ _ 100 ft.). When the RANGE control knob is turned to 5Ft., the detection zone
is very tight and compact, causing the detection sensitivity to be very high.
When the RANGE control knob is turned to Max., the detection zone becomes
very broad, resulting in a low sensitivity.
Detection distance
to MAX.
Time the light stays on after
detecting motion
See customize settings for other
options.
to MAX.
Light
Activation:
3 min.
Walk by Test