Manta MXR101 Manual De Usuario página 12

USING THE APPLIANCE for MXR101A
INSERTING THE BEATERS/DOUGH HOOKS
l Fit the mixer onto the stand by sliding the front of the mixer onto the tab at
the front of the stand. Push down gently on the top of the mixer to clip into
locking mechanism.
l Push the tilt control button on the back of stand and the mixer head back.
l If using as a hand mixer, remove the mixer head from the stand by pressing
the mixer release button.
l Check that the speed switch is in the '0"(OFF) position, then holding each
beater/dough hook by the stem, gently push into the sockets on the
underside of the unit. If necessary, rotate the beaters/dough hooks by hand
until both lock firmly into place. Looking at the underside of the unit, note
that the beater/dough hook with the gear mechanism goes in the left-hand
position. Put the bowl in place.
l Lower the mixer back into its horizontal position by pushing the tilt control
button.
l When the beaters are firmly located, plug the unit into a convenient 220-240
Volt AC power outlet.
MIXING
l Once the mixture is in the bowl, select the speed required by moving the
peed selector with your thumb. The speed may be changed at any time –
even while the mixer is opening.
l The driven bowl will rotate automatically for hands-free operation.
l To ensure all ingredients are thoroughly mixed, use a spatula to scrape the
sides of the mixing bowl.
l To prevent spattering. Keep the beaters in the beaters in the mixture and
always switch the mixer off before lilting the beaters from the mixture.
Important:
To avoid unnecessary strain on the motor, do not use mixer for any mixture in
which the beaters/dough hooks do not revolve freely.
REMOVING THE BEATERS/DOUGH HOOKS
Disconnect the unit from the power outlet. Raise the mixer by pressing the tilt
control button, push the beater/dough hook ejector button down fully with the
thumb, unlocking and ejecting both beaters/dough hooks.
User's Manual
12
E N