Descargar Imprimir esta página

Audiovox RAMPAGE ACD-26 Manual De Operación página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

If a problem should develop while operating the CD player, the following error codes may be displayed on
the LCD panel.
ER-1: Indicates an error in the microprocessor control of the CD player. Eject the disc, make sure it is
ER-2: Indicates a mechanism error or that the disc is not loading or ejecting properly. Try re-loading or
ER-3: Indicates excessive temperature conditions. CD play will resume when the temperature returns to
If the suggested measures do not solve the problem, contact an approved warranty station near you for
further assistance.
Size:
Operating Voltage:
Output Power:
Output Wiring:
Output Impedance:
Low-Level Output:
Tuning Range:
Sensitivity:
FM Stereo Separation:
CD Frequency Response: 20-20,000 Hz. ±1 dB
CD Signal/Noise Ratio:
CD Channel Separation: 60 dB
CD Distortion:
This unit is supplied pre-set at the factory for reception of North American radio stations (10 KHz. channel
spacing on AM/200 KHz. spacing on FM). Use in other areas in the world may require different channel
spacing. A switch on the bottom of the chassis allows selection of 9 KHz. AM/100 KHz. FM channel spacing.
Slide the switch to the appropriate position using a small screwdriver blade. The Re-Set button
front of the chassis must then be pressed to activate the change of channel spacing.
Get user manuals:
See SafeManuals.com
clean, undamaged, and loaded correctly (label side up). Re-load the disc and check for proper
operation or try another disc. You may also try activating the Re-Set button
will also erase the time and pre-set memories.
pressing the Eject button again.
the normal range.
7" W x
2" H x 6-3/8" D
178 mm x 50 mm x 163 mm
12 volts DC, negative ground
120 watts maximum
( 30 watts x 4 channels)
Floating-ground type designed for 4 speaker use.
Front and rear channels CANNOT be combined (bridged) for use with2 speakers.
RCA low-level outputs (rear channels).
Compatible with 4-8 ohm speakers.
2.0 volts (2,000 mv.)
AM: 530-1,720 KHz. (10 KHz. step)
522-1,620 KHz. (9 KHz. step)
FM: 87.5-107.9 MHz. (200 KHz. step)
87.5-108.0 MHz. (100 KHz. step)
AM: 20 uv.
FM: 1.5 uv.
30 dB
70 dB
0.2%
*Specifications are subject to change without notice.
FREQUENCY STEP SWITCH
FREQUENCY STEP SWITCH
FREQUENCY STEP SWITCH
FREQUENCY STEP SWITCH
FREQUENCY STEP SWITCH
ERROR CODES
ERROR CODES
ERROR CODES
ERROR CODES
ERROR CODES
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
cr
on the unit, but this
cr
on the
10 10
10 10
10

Publicidad

loading