Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
Installation of the door handle
1. Open the door.
2. Lift the gasket gently at the area of the screw hole as shown in
picture A.
3. Attach the handle (picture B) to the door frame (matching the
screw holes).
GB
4. Insert each screw from inside then tighten it in a clockwise
rotation.
Reversing the door orientation
The default left side orientation of the glass door can be changed
to the right side. Use the following procedure to change the side of
the door hinge.
• Turn off the wine cooler and disconnect the power plug from the
wall outlet.
• Tilt the wine cooler backwards to an angle of 45 degree and
securely support it.
• Remove the upper hinge cover (Fig. 1: Pos. 6)
• Remove the four screws (Fig. 1: Pos. 1) that hold the upper hinge (Fig. 1: Pos. 5) (right side)
to the frame, Take away the upper hinge (Fig. 1: Pos. 5) (right side)
• Remove the two screws (for GWC2040) or four screws (for GWC2091)
(Fig. 1: Pos. 3) that hold the lower hinge (Fig. 1: Pos. 2) and make sure to remove the lower
hinge (Fig. 1: Pos. 2).
• Lift the door and place it on a padded surface to prevent scratching it.
• Remove the left front leg (Fig. 1: Pos. 4) and transfer it to the right side.
(Only for GWC2040)
• Remove the door supporter (Fig. 1: Pos. 9) and transfer it to the right side.
(Only for GWC2091)
• Remove the handle (Fig. 1: Pos. 8) and transfer it to the right side on the door.
• Move the hole cover plate (Fig. 2: Pos. 7) to the right side.
• Reverse the direction of the lower hinge (Fig. 2: Pos. 2).Then install the lower hinge (Fig. 2:
Pos. 2) onto the left side of the lower frame with two screws.
(Only for GWC2040)
• Install the lower hinge (Fig. 2: Pos. 2) onto the left side of the lower frame with four screws.
(Only for GWC2091)
• Set the door to its place making sure the door seat at the lower hinge (Fig. 2: Pos. 2). While
holding the door in the closed position secure the upper hinge (Fig. 2: Pos. 5) in the top
frame of left side with four screws (Fig. 2: Pos. 1).Please remember that do not tighten the
four screws (Fig. 2: Pos. 1) until the top of the door is leveled with the counter top.
• Install the upper hinge cover (Fig. 2: Pos. 6) on the upper hinge.
Picture A
Picture B
87
A
C
D
B
E
F
Publicidad
