hillvert HT-HECTOR-1200B Manual Del Usuario página 46

• Let engine warm up. Slowly adjust choke control toward RUN position. Wait until
engine runs smoothly before each choke adjustment.
To stop engine
• Move throttle to TURTLE.
• Move gas lever to the far left.
• See engine manual for instruction.
CAUTION: Do not stop engine by moving choke control to CHOKE. Backfire, fire or
engine damage could occur.
Operation notes
• At engine start-up, the engine of your chipper operates under no load at 3600 RPM
until approximately 1200 - 1400 RPM's at which speed the centrifugal clutch engages
and begins driving the rotor.
• Rotor speed is 2400 RPM + / - 200 RPM when engine is at full RPM.
• When viewed from the operator zone, the flywheel turns in a clockwise direction.
This rotation pulls branches into the chipper.
A - Foor plate
B - Engine
C - Operator zone
D - Infeed
• Always wear protective gloves and safety glasses during operation of the chipper.
• If it becomes necessary to push material into the chipper hopper, only use a wood
stick, never your hands or anything steel.
• Always keep your hands out of the chipper hopper.