Publicidad
Idiomas disponibles
Idiomas disponibles
6.8
Table of times
Symbol
Description
t0
Standby: the burner is waiting for a heat request
t1
Standby time for an input signal: reaction time, control box remains in waiting mode for t1
t1l
Flame or flame simulation detected before demand for heat: the control box remains idle.
t2
Initialisation standby time: checking time following the main power start-up
Checks extraneous light or parasite flame during t2: waiting mode for t2l, then lockout: the motor
t2l
does not start
t2p
Oil pre-heating time: waiting mode for t2p, then there is a lockout (if there is a heater)
t3
Pre-purging time: The fan motor is running, then the gas valve is activated
Checks extraneous light or parasite flame during pre-purging: control box goes into lockout at the
t3l
end of t3l
t3i
Spark pre-ignition time
ts
Safety time
t4i
Total spark ignition time
t4l
Reaction time to achieve safety deactivation due to flame loss
t5i
Spark post-ignition time
-
Minimum time to reset the control box using reset button
Minimum time to reset the control box using remote reset
Re-cycles: max. 3 repeats of the complete start-up sequence in the case of flame loss during opera-
tr
tion; the final action at the last attempt following flame failure is a lockout
6.8.1
Operating status indication
Status
Awaiting heat request
Awaiting heat request with continuous purging
Pre-heating time
Pre-purging, or long pre-purging
Safety time without flame
Safety time with flame
Normal operating position
Key to layout
ON
20136933
Start-up, calibration and operation of the burner
OFF
Colour code
RED
ORANGE
GREEN
Reset button
colour
-
ORANGE
Blink
GREEN
Blink
ORANGE
Blink
GREEN
Blink
GREEN
GREEN
Tab. K
28
GB
Value (sec.)
max 600
re-cycles
Seconds
Colour code
-
-
-
0.5
2.5
0.5
2.5
0.5
0.5
0.5
0.5
-
-
-
-
-
2
25
4.5
25
15
25
5
5
15
1
3
0.4
0.8
3
Tab. I
Tab. J
Publicidad
