Attaching the Light Kit
REMEMBER to disconnect the power.
1. Remove the three mounting screws on the
light kit fitter.
2. Connect the wires exiting the bottom of the
motor with the light kit by connecting the
molded adaptor plugs together.
3. Slide the light kit fitter into the switch cup
and secure it using the three screws that
were removed in step 1.
4. Insert the shade into the shade holder and
turn it clockwise to lock in place. Repeat for
the remaining shade.
5. With the power off, insert the 9W CFL light
bulbs (included) into the light kit sockets.
Max 9 watts.
Non-Light Kit Option
1. Remove the three mounting screws on the
black bracket below the motor.
2. Disconnecting the two wire connectors for
light kit. Remove the capacitor & switches
set from switch cap by removing the knurl
nut of speed switch and two screws of re-
verse switch.
3. Replace the capacitor & switches set to ex-
tra switch cap using the knurl nut of speed
switch and two screws of reverse switch re-
moved in step 2.
4. Connect the wires existing the bottom of the
motor with the fan control system, which is
inside the switch cap, by connecting the
molded adaptor plugs together.
5. Slide the switch cap up and secure the
switch cup to the black bracket using the
three screws that were removed in step 1.
RISK OF ELECTRIC SHOCK , THE CONNEC-
TORS PROVIDED IN A CEILING FAN FOR SUP-
PLYING POWER TO AN OPTIONAL LIGHT KIT
SHOULD NOT BE REMOVED UNLESS A LIGHT
KIT WILL BE IMMEDIATELY INSTALLED AND
THAT POWER SHOULD BE TURNED OFF PRIOR
TO CONNECTOR REMOVAL AND LIGHT KIT IN-
STALLATION.
Blade Balancing
All blades are grouped by weight. Because nat-
ural woods vary in density, the fan may wobble
even though the blades are weight matched. The
following procedure should correct most fan
wobble. Check after each step.
1. Check that all blade and blade bracket
screws are secure.
2. Most fan wobble problems are caused when
blade levels are unequal. Check this level by
selecting a point on the ceiling above the tip
of one of the blades. Measure from a point
on the center of each blade to the point on the
ceiling. Measure this distance as shown in
Figure 15. Rotate the fan until the next blade
is postioned for measurement. Repeat for
each blade. Measurement deviations should
within 1/8". Run the fan for 10 minutes.
3. Use the enclosed Blade Balancing Kit if the
blade wobble is still noticeable.
Touching
Ceiling
Figure 15
9.