HAMPTON BAY San Marino Manual Del Propietário página 9

TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT USE A SOLID STATE SPEED
CONTROL WITH THIS FAN. IT WILL PERMANENT-
LY DAMAGE THE ELECTRONIC CIRCUITRY.
Making the Electrical
Connections
REMEMBER to disconnect the power. If
you feel you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
Follow the steps below to connect the fan
to your household wiring. Use the wire
connecting nuts supplied with your fan. Se-
cure the connectors with electrical tape.
Make sure there are no loose strands or
connections.
1. Connect the ground conductor of the 120v
supply (this may be a bare wire or a wire
with green colored insulation) to the green
ground lead(s) of the fan (Figure 12). When
using standard ceiling mounting, there are
two green grounding leads; one from the
ceiling mounting bracket and one from
the ball/downrod assembly. When using
"Close-to-Ceiling" mounting, there is only
one green ground lead from the ceiling
mounting bracket since the ball/downrod
assembly is not used.
2. Connect the fan motor white wire to the
supply white (neutral) wire using a wire nut
(Figure 12).
3. Connect the fan motor black wire to the sup-
ply (hot) wire using a wire nut (Figure 12).
4. Connect the blue wire for the light kit to the
black household supply wire.
5. Turn wire nut connections upward, spread-
ing them apart so the green (ground) and
white wires will be on one side of the outlet
box and the black and blue wires will be on
the other side, and push into the outlet box.
CHECK TO SEE THAT ALL CONNECTIONS ARE
TIGHT, INCLUDING GROUND, AND THAT NO
BARE WIRE IS VISIBLE AT THE WIRE NUTS, EX-
CEPT FOR THE GROUND WIRE.
ELECTRICAL DIAGRAMS ARE FOR REFERENCE
ONLY. OPTIONAL USE OF ANY LIGHT KIT SHALL
BE UL LISTED AND MARKED SUITABLE FOR
USE WITH THIS FAN.
SUPPLY CIRCUIT
Outlet
Box
Green
Grounding
Lead
Ground
to
Downrod
WHITE
BLUE
BLACK WHITE
Figure 12
7.