Accessories; Installation Procedure - Kenwood KDC-C519FM Manual De Instrucciones

Accessories

External view
......... Number of items
1
.........1
3
.........4
5
.........1
7
.........1
2CAUTION
The use of any accessories except for those provided might result
in damage to the unit. Make sure only to use the accessories
shipped with the unit, as shown above.
2
.........4
4
.........1
6
.........2
8
.........1
9
.........1
Europe sales area only.

Installation Procedure

1. To prevent a short circuit, remove the key from the ignition and
disconnect the - battery.
2. Make the proper input and output wire connections for each unit.
3. Connect the wiring harness wires in the following order: ground,
battery, ignition.
4. Install the unit in your car.
5. Reconnect the - battery.
6. Press the reset button.
2WARNING
When drilling a hole in the car chassis to install the unit, check
first that nothing is on the other side.
2CAUTION
• If the fuse blows, first make sure the wires aren't touching to
cause a short circuit, then replace the old fuse with one with the
same rating.
• Do not let unconnected wires or terminals touch metal on the car
or anything else conducting electricity. To prevent a short circuit,
do not remove the caps on the ends of the unconnected wires or
the terminals.
• After the unit is installed, check whether the brake lamps,
blinkers, wipers, etc. on the car are working properly.
• Insulate unconnected wires with vinyl tape or other similar
material.
• Some disc changers need conversion cords for connection. See
the section on "Safety Precautions" for details.
■
Removing the transportation screws
Remove all 3 transportation screws for protecting the internal
mechanism before you start to install the unit.
Transportation
screws
NOTE
After removing the transport screw, retain it carefully and
attach it again before transporting the unit again.
— 14 —