DROP Obelisk Modo De Empleo página 11

SAFETY PRECAUTIONS
Follow the recommended measures below to avoid defects to your diffuser:
1. Clean the device every time you switch from one essential oil combination to another.
2. Do not use detergents, solvents or abrasive products to clean the device.
3. Only use clean water at room temperature to fill the water reservoir. Never use boiling or very
cold water.
4. Do not move the device once it is filled with water.
5. Use the adapter provided by the manufacturer.
6. If you do not use the device for some length of time, remove the plug from the electricity
socket and pour away any water in the reservoir.
7 . Never touch the water level sensor and keep the device out of contact with other objects.
8. Never hold your hand above the ultrasonic plate when the device is turned on. It can be
painful for your hand, as well as damaging for the device.
9. Never wrap the adaptor in paper, plastic or any other similar material, since this will prevent
the adapter from optimally dispersing its heat, which may lead to warping and/or the burning
of the membrane as the result. Never touch the adapter with wet hands.
10. Never use any other fluids than water and a few drops of essential oil(s).
11. Never direct the vapour at walls, ceilings or furniture surfaces, because the resulting conden-
sation could cause damage.
12. Do not attempt to disassemble the device.
13. Never place the device on a loose piece of textile, because this might block the flow of air
and prevent the device from diffusing vapour effectively.
20
PROBLEM SOLVING
In the event of problems, consult the table below
Problem Possible cause
No vapour Using the wrong kind of
water; e.g. tap water with a
high mineral content.
No water in the water
reservoir.
No or abnormal The device needs to be clea-
vapour ned. Essential oils are sticking
to the ultrasonic plate.
The water level is higher than
the maximum level.
Flickering lights Water level indicator is dirty.
Device does not Condensation has collected in
stop, even if the the upper part of the casing.
water reservoir is
empty
Water level indicator is dirty.
No vapour diffu- Water is too cold.
sion. The devise
sprays water
WARNING: Keep out of the reach of children and pets. This diffuser has a one-year factory
guarantee.
Solution
Use distilled or purified water.
Clean the device as advised in the
instructions with clean water and clean the
ultrasonic plate with a cotton bud.
Clean the device and fill with water to the
halfway mark. Add more water once the
device starts to produce vapour.
Remove the excess water and restart
the device.
Clean the device as advised in the in-
structions. Make sure in particular that the
ultrasonic plate is properly cleaned.
Tap lightly on the outside of the casing to
release the water that has accumulated.
Clean the device as advised in the in-
structions. Make sure in particular that the
ultrasonic plate is properly cleaned.
Replace the cold water with warmer
water.
21