Publicidad
Idiomas disponibles
Idiomas disponibles
Warning!
DO NOT operate the switch before the blade cover is installed. Risk of injury!
3， Install the blade cover following the steps as shown in the nether figure.
① Insert the blade cover align the two lines marked in the upper figure.
② Push the blade cover forwards until the retainer fit in a suitable position.
1
MAINTENANCE AND REPAIR
●
Do not rinse the machine with water.
The cutter should be stored in a dry place when it is not in use.
Before every use of this cutter, check whether the blade is in good order and it must be repaired in time if damage
has been found.
The blade should be cleaned and lubricated in time after every use of the cutter. When the cutter is to be used for a
long time the blades should be lubricated during operations interval.
2
10
Publicidad
