Publicidad
Idiomas disponibles
Idiomas disponibles
Be sure to fully activate the wheel brakes when getting in and out of the wheelchair, or when riding in a lift or wheelchair lift.
The wheelchair should be on a flat, stable and level surface.
When getting in or out of the wheelchair, do not climb or put weight on the foot. When trying to extend the arms on the
back, do so only until the arm can be extended without changing your sitting position.
Do not stand in the wheelchair
If you have to lean or lean on the wheelchair, make sure that the front wheels point forward, so that the base of the wheel is
extended, to stabilise the wheelchair.
Seek professional advice when going up or down slopes greater than 10 cm. If you have to stop on a slope, avoid sudden and
rapid movements when moving. Movement can cause instability due to the angle of the chair. Use of the brakes can lead to
accidental braking, uncontrolled movement or sudden stalling. Try not to change direction on a ramp, as this may cause ins-
tability and the chair may tip over.
During use, lock the brakes for all actions.
All wheels must always be in contact with the ground.
When the product is in a stationary position, the brakes must be locked. Do not attempt to move the product if the brakes
are locked.
Ensure that the footrests are engaged.
Ensure that the dismounting axle is securely engaged in the rear wheels and the wheelchair frame.
Be careful when climbing kerbs or when using sloping, uneven or slippery surfaces. Failure to do so may result in a significant
risk of falling or injury.
Do not use the product on wet, icy or snowy slopes.
Be aware of the risk of pinching when using the product.
If any parts are damaged, broken, worn or missing, contact your dealer.
ASSEMBLY AND USE
It is important that these assembly instructions are read and understood before assembling the wheelchair. Before using the
wheelchair, it is necessary to carry out the following steps.
Note: you will only need the 2 special spanners that are in the assembly kit.
Operate the brake from position 1 to position 3: unlock the 2 side brakes from the vertical position to the forward position.
The wheel brake is locked when the wheelchair is packed in the box. When you start assembly, it must be unlocked,
otherwise the wheel will not be assembled correctly.
LIST OF PARTS
a) Parts of the chair
Rear wheel x 2
Version Mai 2023
Left footrest x 1
Right footrest x 1
Front roller x 2
15
Publicidad
