Publicidad
Idiomas disponibles
Idiomas disponibles
power.
NoTE: if the battery is defective, the
red light on the charger will flash.
The lights will only function when
the charger is connected to both the
battery and wall receptacle.
7. The charger is a smart charger and can
stay connected to the battery and wall
receptacle for extended periods of time
without fear of damaging the battery or
charger. The charger will automatically
cycle on and off periodically to ensure the
battery is fully charged.
baTTEry CarE
The battery in your cordless lawnmower is a
36-volt sealed lead acid system. The mower
can be stored in any position without fear of
leakage.
•
For optimal battery life and performance
the battery should be fully charged every 2
months during storage
•
For optimal battery life and performance
the battery should be fully charged after
each use
14
14
•
Store the battery in a cool dry location.
•
The battery can be safely stored down to
14°F (-10°C).
•
The battery does not need to be fully
discharged before recharging.
•
Initially 2 to 3 charging cycles may
be required after purchase to achieve
maximum run time capacity.
The battery is maintenance free. ADDITIONAL
BATTERIES can be obtained from the
Customer Helpline 1-866-354-9679.
ASSEMBLY/ADJUSTMENT
warNiNg! Do not connect the battery
and/or the safety key before product is
completely assembled.
1. aSSEmbliNg ThE haNdlE (See C)
Raise the handle section into place and secure
by tightening the two Locking cam levers.
Check that the handle is FULLY secured.
The cam lever (4) pressure can be adjusted
by rotating the screw knob (15) clockwise/
counter-clockwise. DO NOT OVER TIGHTEN
3-in-1 cordless lawn mower
2. aSSEmbliNg ThE graSSbag
(See d1, d2 & d3)
1) Before starting to assemble the grass
bag to the frame (b), check that the grass
bag is positioned to slip over the frame.
2) Slide the grass bag onto the frame.
3) Assemble the top clips to the
frame, and then assemble the two
side clips and the bottom clip.
3. FiTTiNg/rEmoviNg baTTEry (See E, F)
rEmoviNg baTTEry
Disconnect the connector (c), then rotate the
battery locking knob (d) counter-clockwise.
Remove the battery by lifting it out of the
mower by the battery handle. (See F)
NoTE: Be careful not to drop the battery onto
your foot or on the ground when removing it.
FiTTiNg baTTEry
Put the battery into the battery container,
connect the battery connector (c)
and then rotate the battery locking
knob clockwise (d). (See E)
4. iNSTalliNg ThE graSS
bag (See g1,g2 & g3)
FiTTiNg
1) Turn the mower off, wait until blade
stops and remove safety key.
2) Raise the safety guard and hold
it up, ensure that the mulching
plug has been removed.
3) Pick up the grass bag by the handle,
and position grass bag on the two
lower grommets (e) on the bottom
edge of the mower deck. Raise the
bag to its full horizontal position.
4) Release the safety guard to lock the grass
bag into position. Lift the handle slightly to
ensure the grass bag is installed securely.
NoTE: Depress the grass bag slightly to
ensure that it is completely installed.
rEmoviNg/EmPTyiNg
Lift the safety guard and hold it up. The
grass bag will drop automatically.
5. adjUSTiNg ThE CUTTiNg
hEighT (See h)
warNiNg! Stop, release safety bail
and wait until the motor stops before
EN
Publicidad
