Ryobi Pi1824QBT Manual Del Operador página 12

PROBLEM
Cooler does not Cooler is not properly
work. connected to power.
Blown fuse.
Switching the cooler on/off too
frequently may cause delayed
start of the compressor.
Cooler The door has been opened too
compartments are frequently.
too warm.
A large amount of warm or hot
food was stored recently.
The cooler has been
disconnected for a long time.
Food is frozen. The temperature is set too low.
There is a sound This is a normal sound caused
of water flow from by the flow of refrigerant.
inside the cooler.
Condensation The lid is not closed.
around the edges of
Cool air is escaping the
the lid.
cooler and causing water to
condense.
The compressor is Cooler has not fully started.
noisy when starting.
OPERATION
TROUBLESHOOTING
POSSIBLE CAUSE POSSIBLE SOLUTION
Ensure cooler is switched on.
Check if the battery has been charged.
Check if the plug and socket are connected well.
Check if the power supply is malfunctioned.
Check and/or replace fuse.
Disconnect the power to the cooler for five minutes and
restart.
Close the door and allow the cooler to reach desired
temperature.
Allow food to cool slightly before putting in cooler.
Connect cooler and allow adequate cooling time prior to use.
Refer to temperature recommendations section in manual.
If noise persists, turn cooler off and let it sit in the upright
position for 24 hours or call customer service.
Clear anything preventing the lid from closing.
This is normal. Noise will reduce once cooler has fully started.
No action is required.
10 — English