Maintenance And Warranty; Troubleshooting - IONSTAR 14883 Manual De Instrucciones

8. Maintenance and warranty

The IONSTAR warranty begins with the date of purchase by the end customer.

Maintenance with standard warranty (2 years)
The annual Inspection is not mandatory for the IONSTAR, but we highly
recommend it, as routine inspections of commercially used electrical
systems are usually required by law and for Insurance and/or fire safety
purposes

Maintenance with extended warranty (5 years)
The inspection of the IONSTAR is mandatory on a regular basis, at least
1x per year
For more information about maintenance and warranty, please contact us at
+49 (0) 9762 9397 624.
We are available for you Mon-Thu 9am-5pm and Fri 9am-3pm.

9. Troubleshooting

problem
No ionization
IONSTAR does not
work
Warning light lights up
red
Warning light flashes
green
Spark discharge (arc-
over)
Please note:
measures described above, the unit can be sent to us the manufacturers, Herrmann
Innovations GmbH for inspection at the address below.
Herrmann Innovations GmbH
Abt.: Service & Technik
Bahnhofstraße 32
93483 Pösing
Germany
cause
Air pressure set too low
Compressed air flow
interrupted
Air pressure set too high
Air pressure set too low
The ionizing device is damaged
In case a fault or malfunction occurs, which cannot be rectified using the
Set air pressure to 2.5 - 3.5 bar
Check couplings, compressed air
system and compressor
Reduce the inlet air pressure so that
it is a maximum of 3.5 bar
Increase the input air pressure to 2.5
bar
Take the device out of service
immediately
Internet: www.herrmann-innovations.com
E-Mail: info@herrmann-innovations.com
Tel.: +49 (0) 9762 9397 624
Seite 25 von 44
action necessary