Publicidad
Step 20
Flip the drawer over onto the LEFT DRAWER SIDE (D32).
å
Diagram 1. Insert the tabs on a DRAWER STOP (20G) into the slots in an
å
EXTENSION SLIDE (X). You may need to insert one tab fi rst, then the other.
Diagram 2. Visually check that the DRAWER STOP (20G) is seated in the SLIDE (X).
å
Diagram 3. If the DRAWER STOP is not seated, use your hammer to gently tap
å
the SLIDE until the tabs are properly seated in the slots.
Now, fasten the EXTENSION SLIDE (X) to the RIGHT DRAWER SIDE (D33). Use
å
two GOLD 5/16" FLAT HEAD SCREWS (3S) through holes #1 and #3.
These tabs must insert into the slots.
2.
20G
3.
www.sauder.com/services
Slot
1.
X
Post
X
Seated
20G
412015
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
X
3
4
D33
D32
Open end
1
2
Page 25
Publicidad
