Publicidad
Step 4
Diagram 1. Measure 1-1/2" from one end of the INTERLOCK TRACK (22G). Position the
å
INTERLOCK TRACK as shown.
SAFETY STOP / TRACK ATTACHMENT:
å
Diagram 2. Tilt the fi rst edge of the INTERLOCK TRACK (22G) into the SAFETY STOP (29G).
å
Diagram 3. Rotate the INTERLOCK TRACK and apply force to snap the second edge into the
å
SAFETY STOP.
Diagram 4. Repeat the SAFETY STOP/ TRACK ATTACHMENT for the next SAFETY STOPS
å
while holding the previously completed SAFETY STOP in its location hole. Visually check
that all INTERLOCK TRACK edges have been snapped into the SAFETY STOPS as shown in
diagram 3.
Diagram 5. Remove the INTERLOCK TRACK assembly from Diagram 4 and fl ip it over
å
before inserting the INTERLOCK TRACK (22G) with SAFETY STOPS (29G) into the groove
in the INSIDE RIGHT END (C3).
2.
www.sauder.com/services
STOP
Be sure the
interlock track
snaps into each
safety stop.
22G
3.
29G
Cut out this rectangle
to use as a "spacer"
1-1/2"
C3
C3
412015
1.
22G
4.
29G
22G
5.
22G
Page 9
Publicidad
