Grouw 18721 Manual De Instrucciones página 45

country where the log splitter is used.
Do not discharge into drains, soil or water.
Maintain your log splitter with care
Keep the log splitter clean for best and
safest performance.
Make the workshop childproof
Lock the shop. Disconnect master
switches. Store the log splitter away from
children and others not qualified to use it.
SET UP AND PREPARATION FOR
OPERATION
1. Bolt the Support Leg to the Log Splitter,
lift the log splitter by the handles at both
ends and place it on a 60 – 75cm high,
stable, flat and level work surface.
The log splitter is heavy - make sure that
you are 2 persons to lift it.
2. Familiarize yourself with the controls
and features of this log splitter in the
illustration.
1. Log Pusher
2. Work Table
3. Shield
4. Support Leg
5. Switch
6. Motor
7. Pushbutton Box
8. Wheels for Minor Moving ONLY.
9. Hydraulic Control Lever.
Before operating the log splitter, the
Bleed Screw should be loosened by some
rotations until air can go in and out of the
oil tank smoothly.
Air flow through the Bleed Screw hole
should be detectable during the log
splitter is under operations.
Before moving the log splitter, make sure
the Bleed Screw is tightened to avoid oil
leaking from this point.
Failure to loosen the bleed screw
will keep the sealed air in hydraulic
system being compressed after being
decompressed. Such continuous air
compression and decompression will
blow out the seals of the hydraulic
system and cause permanent damage to
the log splitter.
10. Control Lever Guard
11. Bleed Screw
12. Oil Drain Bolt w/ Dipstick
13. Venting screw
14. Bolt for draining oil
45
GB