Publicidad
Idiomas disponibles
Idiomas disponibles
Manual
Finimaster Basic
opposite to the grinding wheel's movement at
the point of snagging.
d) Use special care when working corners,
sharp edges etc. Avoid bouncing and sna-
gging the accessory. Corners, sharp edges or
bouncing have a tendency to snag the rotating
accessory and cause loss of control or kickback.
and cause loss of control or kickback.
5.3 Additional Safety Instructions
WARNING
Always wear protective goggles.
Wear ear protectors!
Observe the specifications of the tool or acces-
sory manufacturer!
The workpiece must lay flat and be secured
against slipping, e.g. using clamps. Large work-
pieces must be sufficiently supported.
Make sure that the thread in the accessory is
long enough to accommodate the full length
of the spindle. The thread in the accessory must
match the thread on the spindle. See chapter 14.
Technical Specifications for more information on
the spindle length and thread.
Damaged, eccentric or vibrating tools must not
be used.
Avoid damage to gas or water pipes, electrical
cables and load-bearing walls (static).
Pull the plug out of the socket before making
any adjustments, converting or servicing the
machine.
A damaged or cracked side handle must be
replaced. Never operate a machine with a defec-
tive side handle.
A damaged or cracked safety guard must be
replaced. Never operate a machine with a defec-
tive safety guard.
5.4 Reducing dust exposure
Observe the relevant guidelines for your material,
staff, application and place of application (e.g. oc-
cupational health and safety regulations, disposal).
Use a suitable extraction unit.
Reduce dust exposure with the following
measures:
- Do not direct the escaping particles and
the exhaust air stream at yourself or nearby
persons or on dust deposits.
- Use an extraction unit and/or air purifiers.
- Ensure good ventilation of the workplace
and keep it clean using a vacuum cleaner.
Sweeping or blowing stirs up dust.
- Vacuum or wash protective clothing. Do not
blow, beat or brush.
6.
OVERVIEW
See page 2.
1
Electronic signal indicator
2
Sliding on/off switch
3
Spindle locking button
4
Handle bar
5
Clamping lever
6
Additional handle
7
Safety guard
8
Spindle
9
Speed adjustment wheel
10 Tool fixing screw
11 Tensioning spindle
EN
Finimaster Basic Ι
31
Publicidad
