Cibo Finimaster Basic Manual página 32

EN
7. COMMISSIONING
Before plugging in, check that the rated
mains voltage and mains frequency, as
stated on the type plate match your power
supply.
Always install an RCD with a maximum trip
current of 30 mA upstream.
Safety guard
As illustrated, screw the safety guard (12) with
the additional handle (11) into one of the
threaded holes of the handle bar (9). Keep the
distance to the tool as short as possible. Tighten
the additional handle by applying force.
Handle bar
The handle bar (9) must be fitted as far as
the limit stop on the gearbox flange.
After releasing the clamping lever (10), the hand-
le bar (9) can be turned to the desired position.
Firmly tighten the clamping lever (10) again. The
position of the lever might need to be changed
for this purpose. The position of the lever can be
changed without turning the clamping screw.
For this purpose, raise the lever, turn it and then
lower the lever again (see illustration, page 2).
When working, always position the lever in
a way that it cannot come into contact
with the tool.
Tensioning spindle
Screw the tensioning spindle (10) onto the
spindle (4) while holding in the spindle locking
knob (2) and tighten with an open-ended
spanner (12).
32 Ι Finimaster Basic
8. USE
8.1 Adjusting the speed
Set the recommended speed at the thumb-
wheel (10). (small number = low speed; large
number = high speed)
8.2 Switching On and Off
Always guide the machine with both
hands.
Switch on first, then guide the accessory
towards the workpiece.
The machine must not be allowed to draw
in additional dust and shavings. When
switching the machine on and off, keep it
away from dust deposits. After switching off the
machine, only place it down when the motor
has come to a standstill.
Avoid inadvertent starts: always switch the
tool off when the plug is removed from
the mains socket or if there has been a
power cut.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine
with both hands using the handles provided,
stand securely and concentrate.
0
Switching on: Push the sliding switch (7)
forward. For continuous activation, now tilt
downwards until it engages.
Manual
Finimaster Basic
2
I