Publicidad
Idiomas disponibles
Idiomas disponibles
PROBLEMS
but loses under
load
Tool runs
slowly. Air
flows slightly
from exhaust
Tools will not
run. Air flows
freely from
exhaust
Tool will not
shut off
Note: Repairs should be carried out by a qualified person.
12
ENVIRONMENT
Should your appliance need replacement after extended use, do not discard it with the
household rubbish but dispose of it in an environmentally safe way.
Copyright © 2021 VARO
POWAIR0013
POSSIBLE CAUSES
Cam clutch worn or
sticking due to lack of
lubricant.
Motor parts jammed
with dirt particles
Power regulator in
closed position
Air flow blocked by dirt.
One or more motor
vanes stuck due to
material build up.
'O' rings throttle valve
dislodged from seat
inlet valve.
P a g e
REMEDIES
can cause drag on high speed clutch
parts, i.e. a typical oiled/lubricated
wrench requires 1⁄2 ounce of oil.
GREASE
LUBRICATED:NOTE: Heat
usually
insufficient
chamber.
operating conditions may
require
lubrication.
Check air inlet filter for blockage.
Pour air tool lubricating oil into air inlet
as per instructions.
Operate tool in short bursts quickly
reversing rotation back and forth
where applicable.
Repeat above as needed.
Pour air tool lubricating tool into air
inlet.
Operate tool in short bursts of forward
and/or reverse rotation where
applicable.
Tap motor housing gently with plastic
mallet.
Disconnect supply. Free motor by
rotating drive shank manually where
applicable
Replace 'O' ring.
| 5
EN
indicates
grease
in
Severe
more
frequent
www.varo.com
Publicidad
