Descargar Imprimir esta página

Trevi XF 470 KB Guia Del Usuario página 13

Altavoz amplificado con bluetooth/mp3-usb-micro sd/luz de disco
Ocultar thumbs Ver también para XF 470 KB:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

IMPORTANT
-
Dispose of used batteries in accordance with the recycling regulations in
your area.
-
Danger of explosion if battery is incorrectly replaced.
-
Replace only with the same or equivalent type.
-
If the remote control is not used for a long time, the battery may leak and
damage the remote control, replace it with a new one if this occurs.
-
DO NOT short-circuit the batteries or throw them into water, general garbage
or fire.
CHARGING THE BATTERY
1. With the appliance off, connect the power supply cable to the charging port
type-C(13) on the device. Connect the cable to a 5V
supplied) and the latter to a mains socket;
2. The Led indicator(12) will light up Red;
3. When charging is complete, the LED indicator(12) will switch off;
4. With low battery, the last segment of the battery icon on the display will
flash for a certain time, then the device will switch off automatically.
Note: For a good battery life, it is recommended to keep the device off during the
charging.
Unless otherwise specified, the commands described below apply to both the
unit and the remote control.
ON/ OFF
-
Press and hold the button
and hold it again for 2 seconds to turn Off the device.
-
Press the button
VOLUME/ MUTE/ TONE/ ECHO/ EQ
1. Rotate the Volume knob (4) clockwise/counterclockwise to increase/decrease
the volume of the unit. Press the button
mute the device, press it again to return to normal listening;
2. Press the Volume knob (4) several times and rotate it to adjust: treble, bass,
microphone volume, Echo, and Delay;
3.
Press the EQ(17) button several times to choosing from the pre-set ones:
EQ00, EQ01, EQ02, EQ03, EQ04, EQ05.
RADIO MODE
1. Press MODE button(1) on the speaker to switch to FM mode;
2. Short press PLAY(6) button to enter automatic search for FM channels;
3. Press PREV(7) or NEXT(5) button to go to the next or previous frequency.
MUNE
(2) for 2 seconds to turn On the appliance; press
LED
(15) on the remote control to turn the appliance on/off.
LED
1A power supply (not
MUNE
(25) on the remote control to
13

Publicidad

loading

Este manual también es adecuado para:

0x047000